Pacific Aerials
Part number: 39-P5027M
Pack size: EA
Type: 2 Circuit + Memory 
Volt In: 24V 
Volt Out: 12V 
Amp/Watt: 10A + 0.1A 
Feature:

Part # 39-P5027M

Pacific Aerials Switchmode Reducer

100mA Switched Accessory Memory Output - 10 Amp (14 Amp Peak)

Suits:
Car Audio CD / MP3 / DVD Head Units, land mobile radio (25W); medium power electronics

  • Ideal for high vibration / high impact services
  • Small size - easily installed - fits anywhere
  • Supplied with cable connectors, clip-on mounting brackets and screws
  • Manufactured in New Zealand
  • EMC Testing: AS/NZS2064, EN50081-2
  • Compliance marking: C-tick, CE mark
  • Output and fault indicators: Green & Red LED's
  • Input Voltage: 15 - 38V
  • Output Voltage: 13.2V
  • Peak load is available for a maximum of 5 minutes in each 20 minutes
  • Typical Efficiency: >90%
  • Temperature rating: -25 C to +30 C
  • Over Temperature use: Above 30 C ambient, reduce continuous load by 2% per degC
  • Humidity: Maximum 95% non-condensing
  • Case Material: T6063 marine grade aluminium, anodised
  • Electrical Protection: Reverse input connection, output over current, output over voltage, transients
  • Over Teperature Protection: Yes
  • Enviromental Protection: IP533 dust, water and impact resistance
  • Transient voltage protection: ISO7637-2
  • Electrostatic voltage protection: ISO10605/14982. >8kV contact and 15kV discharge
  • Output Noise: CISPR25,
  • Colour: Blue

Sizes:95 x 75 x 32mm

WIRING & INSTALLATION INSTRUCTIONS
The "Input" and "Output" terminals are connected to the MAIN
Reducer circuit. Connect whichever wire is the largest (carries the main
feed/most current) through this circuit - and the other wire (if present)
through the "ACC In" and "ACC Out" terminals.
Some later model Head Units may have the YELLOW Memory Wire as
the main feed. In this case, connect it through the Input and
Output MAIN terminals and the RED wire to "ACC In" and "ACC Out".
NOTE: When welding on a vehicle where these Reducers have been installed,
disconnect the Battery !!!
Failure to do so will result in Reducer damage and void Warranty !

LIFETIME WARRANTY !
WARRANTY IS VOID IF END COVER IS REMOVED
- DO NOT OPEN FOR INSPECTION !!!

For more information click on the PDF link below